ESP-WROOM-32 AT commands firmware

[WiFive]

It might be configured to UART1 pins 16 & 17

https://github.com/espressif/esp32-at/b ... faults#L44

[rudi ;-)]

hi
only a thinking, have not tested just in time ( later time )
can we use uart0 as AT command port, too ?
does it be enough to set it in the sdkconfig ?

best wishes
rudi

[rudi ;-)]

https://github.com/espressif/esp32-at/b ... ask.c#L363

fast and dirty custom at

3.png (44.43 KiB) Viewed 13062 times

best wishes
rudi

[wind_energy]

rudi can you send me yours bin files? I still have now working at all ... I made connection to UART1 with no results ...

[rudi ;-)]

hi
can you not compile too?
will prepair this next step.

checkt this steps:

- ? gnd connect between the esp32 modul and the "terminal usb adapter/uart1 brigde"
- ? Rx, Tx not swapped
- ? CR+LF at and of AT Command
- ? after boot, the log is on UART0, the ready for AT Command comes on UART1
..

fyi:
why you connect to the pins of modul and not to the pinheader 16,17, GND?
have a look:

IMG_5938_s1.jpg (328.07 KiB) Viewed 13061 times

tested with DevKitC and FTDI 232 ( bridge the uart1 out for AT Commands..)

best wishes
rudi

[wind_energy]

rudi - many thanks !!!! all works fine !!
thank you

[rudi ;-)]

edit:
fine!
so you do not need the bin files any more?
ok - have phun!!


best wishes
rudi

[wind_energy]

at the moment don`t need it thanks any way

[rudi ;-)]

at the moment don`t need it thanks any way

ok Pawel - have phun!

best wishes
rudi

[rudi ;-)]

hi
only a thinking, have not tested just in time ( later time )
can we use uart0 as AT command port, too ?
does it be enough to set it in the sdkconfig ?

best wishes
rudi

yes we can
( fine with make flash monitor too )

7.png (69.42 KiB) Viewed 13041 times

you do not need any more USB Adapter or others.
simple flash over the usb cable ( uart0 )
simple monitor over the usb cable ( uart0 )

5.png (41.13 KiB) Viewed 13048 times

best wishes
rudi

"only one thing": uart_wait_tx_done(703): uart driver error