This problem is about the Arduino-ESP32 Rainmaker demo

fary_young
Posts: 11
Joined: Tue Dec 15, 2020 5:57 am

This problem is about the Arduino-ESP32 Rainmaker demo

Postby fary_young » Fri Jun 18, 2021 1:55 am

I tried to use the Rainmaker example provided by Arduino-ESP32, but when I ran it, I printed out the result like this. How can I solve this problem?
QQ图片20210618095226.png
QQ图片20210618095226.png (12.76 KiB) Viewed 25023 times

ESP_Piyush
Posts: 310
Joined: Wed Feb 20, 2019 7:02 am

Re: This problem is about the Arduino-ESP32 Rainmaker demo

Postby ESP_Piyush » Fri Jun 18, 2021 2:50 am

Seems that your board already had the Wi-Fi credentials stored in the persistent memory (NVS) while your programmed it with the ESP RainMaker firmware. Please press and hold the BOOT button for more than 3 seconds and then release so that the credentials get erased . Thereafter, repeat the provisioning using the ESP RainMaker phone apps.

fary_young
Posts: 11
Joined: Tue Dec 15, 2020 5:57 am

Re: This problem is about the Arduino-ESP32 Rainmaker demo

Postby fary_young » Fri Jun 18, 2021 10:39 am

Hello, thank you for your answer. After trying according to your method, the QR code can be successfully output, but the style interval of the QR code is too large to identify the information. How should I solve this problem?
QQ图片20210618183852.png
QQ图片20210618183852.png (10.25 KiB) Viewed 24983 times

John__
Posts: 20
Joined: Sun Nov 15, 2015 4:17 am
Contact:

Re: This problem is about the Arduino-ESP32 Rainmaker demo

Postby John__ » Sun Jun 27, 2021 5:16 am

Hi there, It looks like you are using windows. The serial monitor on windows cannot properly display the 2D barcode but there are 2 solutions:

1. Use a different serial monitor as I did here: https://youtu.be/g-Mw0-lzxdg

2. Enter the credentials manually as I mention in this video: https://youtu.be/g-Mw0-lzxdg

Hope this helps :)

marcelstoer
Posts: 11
Joined: Sun Aug 23, 2020 8:09 pm

Re: This problem is about the Arduino-ESP32 Rainmaker demo

Postby marcelstoer » Fri Jul 09, 2021 8:49 am

fary_young wrote:
Fri Jun 18, 2021 10:39 am
the QR code can be successfully output, but the style interval of the QR code is too large to identify the information
Right below the QR code you should also see a URL that you can paste into any browser. I will render the same QR code there.

Baruna1221
Posts: 1
Joined: Mon Jun 03, 2024 9:55 am

Re: This problem is about the Arduino-ESP32 Rainmaker demo

Postby Baruna1221 » Mon Jun 03, 2024 10:02 am

Why my serial monitor in arduino ide cannot display qrcode? I already install library esp32, etc
Attachments
2024-06-03-17-01-31-691.jpg
This is my serial monitor in arduino ide
2024-06-03-17-01-31-691.jpg (5.95 MiB) Viewed 5460 times

Who is online

Users browsing this forum: No registered users and 11 guests