I am using Espressif IDF extention v0.6.1.
After flashing, i open the monitor which works just fine.
However, if I recompile and try to flash again I get an error saying "SerialException: could not open port..."
I know this is because it did not close the com port before it started flashing.
Can you guys fix this please, this was an issue before and was fixed but now its back again.
Espressif IDF extention issue flsah / monitor
-
- Posts: 229
- Joined: Wed May 02, 2018 12:12 pm
Re: Espressif IDF extention issue flsah / monitor
Can you open an issue in the Github repository here
We need more information about your setup and steps to reproduce this issue.
We need more information about your setup and steps to reproduce this issue.
Who is online
Users browsing this forum: No registered users and 19 guests