AT command is not working
Posted: Mon Jan 02, 2023 5:58 pm
Hi,
I downloaded the ESP32-PICO-D4-V2.4.0.0 and flashed it to the ESP32-PICO
The flashing worked and I can se the startup on the log port.
I connect the other serial port on 19 and 22 and after the reset of the ESP32-PICO i get the message 'ready' on the console output of the AT serial port. I try to send AT adding cr and lf but I do not get any response. The speed is correct since I receive the 'ready' message. I do not have any flow control in the terminal program since this is not nessecary according to your document.
Is the provided bin file incorrect or what is wrong ?
Best regards
I downloaded the ESP32-PICO-D4-V2.4.0.0 and flashed it to the ESP32-PICO
The flashing worked and I can se the startup on the log port.
I connect the other serial port on 19 and 22 and after the reset of the ESP32-PICO i get the message 'ready' on the console output of the AT serial port. I try to send AT adding cr and lf but I do not get any response. The speed is correct since I receive the 'ready' message. I do not have any flow control in the terminal program since this is not nessecary according to your document.
Is the provided bin file incorrect or what is wrong ?
Best regards