Light Sleep with BLE
Posted: Mon Apr 11, 2022 7:28 am
Hello,
I'm using WROVER-IE module with AT binary version v2.2.0.0. I connected 32.768khz crystal with parallel resistor of 10Mohm according to hardware design guidelines document. (Pins: GPIO32 and GPIO33)
When i follow AT light sleep example commands, i can't put my module in light sleep mode. I can tell from module's current consumption. When i read sleep status via AT command, module response is "+SLEEP:3"
What i am doing wrong here? Can you help me for this problem?
I'm using WROVER-IE module with AT binary version v2.2.0.0. I connected 32.768khz crystal with parallel resistor of 10Mohm according to hardware design guidelines document. (Pins: GPIO32 and GPIO33)
When i follow AT light sleep example commands, i can't put my module in light sleep mode. I can tell from module's current consumption. When i read sleep status via AT command, module response is "+SLEEP:3"
What i am doing wrong here? Can you help me for this problem?