AT+BTA2DPINIT with I2S

[pedroATsms]

Hi all,

I have a couple of questions about A2DP.

Using a ESP32 with AT, I have enabled A2DP support, which gives 3 I2S pins. My questions are -

1) is the I2S a master or slave?

2) What difference will the +BTA2DPINIT sink or source make to the I2S function?

Thanking you
Pedro

[ESP_Sun]

Hi,

1) I2S is the master.

2) AT+BTA2DPINIT is source without I2S, AT+BTA2DPINIT is sink will use I2S to control peripherals to play audio.

Hope this helps you.

[pedroATsms]

Thank you for your reply ESP_Sun.

If I understand your reply correctly, then:-

BT Sink -> I2S Master
BT Source -> No I2S

If BT Source has no I2S, how do I give it the audio?

Kind regards
Pedro

[ESP_Sun]

Thank you for your reply ESP_Sun.

If I understand your reply correctly, then:-

BT Sink -> I2S Master
BT Source -> No I2S

If BT Source has no I2S, how do I give it the audio?

Kind regards
Pedro

Yes, BT source does not have I2S. It executes the AT+BTA2DPSRC command and provides audio for it through the URL, but there is a issue with the current version of the AT+BTA2DPSRC command.