WARNING: ESP32-S2 (revision v0.0) chip was placed into download mode using GPIO0.

[poufblacky]

Hi all,
I encountered this issue and cannot flash my ESP32-S2-DevKitC1.
I'am using Arduino IDE 2.3.4 on this ESP32.
I selected the correct port (COM4) and selected the correct board (ESP32SE Native USB).

I just wanted to upload the first "Hello world" program in the ESP32 board but this warning appears when I uploiad the program

Does someone encounter the same issue? How did you fix it?

I have tried :
- to press button "Reset" but nothing happened.
- to press and maintain button "Boot" and then press and release "Reset" but it just says the "ESP32S2 Native UBS on COM4 [not connected]" then "connected" after release of button "Reset"

I have looked on several forums but didn't find a real solution.