Using DAC2 on ESP32-S2-Mini-1U

[MarkusR]

Hi,

the documentation says that this pin is pulled up to 3v3 via 10K resistor, if I want to use this DAC output does that mean I have to remove the shield and remove R11 first?

Hic6or.png (10.26 KiB) Viewed 2112 times

gs1eAO.png (15.01 KiB) Viewed 2112 times

https://www.espressif.com/sites/default ... eet_en.pdf

The problem I see is that DAC 2 is stuck at 2.68V while DAC 1 just works fine.

[yuliksan]

Hi, MarcusR
Did you solve the problem?


Thanks

[PepeTheGreat]

Same issue. Why is there a 10k to vcc? To keep rx1 up?

Removing this should help: https://imgur.com/a/4MqclGo