Deep sleep not working with ESP BLE MESH
Deep sleep not working with ESP BLE MESH
I have been trying to use BLE Mesh along with Deep sleep. The code works fine and it looks like the esp is going into deep sleep. However, when I measure the energy consumed using a multimeter, I see it is consuming around 60mA on average. It would be great if some could guide me on this. I am attaching my code below as zip. The code basic reads GPIO which is connected to a motion sensor. Sends the data to client and goes to sleep. It wakes up again after TIME_TO_SLEEP_IN_MINUTES minutes (which is set to 0.5) and repeats the same steps.
- Attachments
-
- sensor_server.zip
- (7.61 KiB) Downloaded 398 times
-
- Posts: 20
- Joined: Thu Nov 02, 2017 12:40 am
Re: Deep sleep not working with ESP BLE MESH
Are there other devices like a LDO regulator or USB to Serial chip on your ESP32 board that could be consuming power?
Who is online
Users browsing this forum: Google [Bot] and 65 guests