Log output is UART0 by default. Can not change to UART1?

Post Reply
readingmb
Posts: 3
Joined: Wed Jun 15, 2016 5:47 am

Log output is UART0 by default. Can not change to UART1?

Postby readingmb » Tue Jan 24, 2017 12:33 am

Log output is UART0 by default. Can not change to UART1?
Or can I turn off the Log output?
Top
WiFive
Posts: 3529
Joined: Tue Dec 01, 2015 7:35 am

Re: Log output is UART0 by default. Can not change to UART1?

Postby WiFive » Tue Jan 24, 2017 1:15 am

Menuconfig, components, esp32
Top
User avatar
kolban
Posts: 1683
Joined: Mon Nov 16, 2015 4:43 pm
Location: Texas, USA

Re: Log output is UART0 by default. Can not change to UART1?

Postby kolban » Tue Jan 24, 2017 1:15 am

If you run "make menuconfig" and then navigate to Component Config -> ESP32 specific you will find an entry called "UART for console output" where you can select UART0 or UART1 ... or none.
Free book on ESP32 available here: https://leanpub.com/kolban-ESP32
Top
readingmb
Posts: 3
Joined: Wed Jun 15, 2016 5:47 am

Re: Log output is UART0 by default. Can not change to UART1?

Postby readingmb » Tue Jan 24, 2017 6:19 am

oh! Thank very much.
Top
Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: snutw_, Vitalii_Bondarenko and 77 guests