Not able to configure GPIO2 as input in ESP32­WROOM­32E

[alpesh_st]

Hey,

We are currently facing an issue with the configuration of GPIO2 on our ESP32-WROOM-32E board. When configured as an input with an external pull-up resistor and running firmware developed using the Espressif IDE, GPIO2 is not detecting low inputs as expected. All other GPIO pins are functioning correctly under similar configurations.

We would greatly appreciate any insights or further troubleshooting steps you could provide to help us resolve this issue. Your expertise and guidance in this matter would be invaluable.

Thank you for your assistance, and we look forward to your response.

Thanks.
--Alpesh