As a beginner, I ask for your support
According to the documentation, ESP32 can receive 3 types of frames: Control, Management, Data.
My program receives frames: Management, Data and does not receives Control.
What am I doing wrong?
- /*
- ===========================================
- Copyright (c) 2017 Stefan Kremser
- github.com/spacehuhn
- ===========================================
- */
- /* include all necessary libraries */
- #include "freertos/FreeRTOS.h"
- #include "esp_wifi.h"
- //#include "esp_wifi_internal.h"
- #include "lwip/err.h"
- #include "esp_system.h"
- #include "esp_event.h"
- #include "esp_event_loop.h"
- #include "nvs_flash.h"
- #include "driver/gpio.h"
- #include <Arduino.h>
- #include "TimeLib.h"
- #include "FS.h"
- #include "SD.h"
- #include "SPI.h"
- #include "PCAP.h"
- //===== SETTINGS =====//
- #define CHANNEL 5
- #define BAUD_RATE 921600
- #define CHANNEL_HOPPING false //if true it will scan on all channels
- #define MAX_CHANNEL 11 //(only necessary if channelHopping is true)
- #define HOP_INTERVAL 214 //in ms (only necessary if channelHopping is true)
- //===== Run-Time variables =====//
- PCAP pcap = PCAP();
- int ch = CHANNEL;
- unsigned long lastChannelChange = 0;
- wifi_promiscuous_filter_t filter = {
- //.filter_mask = WIFI_PROMIS_FILTER_MASK_ALL
- //.filter_mask = WIFI_PROMIS_CTRL_FILTER_MASK_ALL
- .filter_mask = WIFI_PROMIS_FILTER_MASK_MGMT | WIFI_PROMIS_FILTER_MASK_CTRL | WIFI_PROMIS_FILTER_MASK_DATA
- };
- //===== FUNCTIONS =====//
- /* will be executed on every packet the ESP32 gets while beeing in promiscuous mode */
- void sniffer(void *buf, wifi_promiscuous_pkt_type_t type)
- {
- wifi_promiscuous_pkt_t* pkt = (wifi_promiscuous_pkt_t*)buf;
- wifi_pkt_rx_ctrl_t ctrl = (wifi_pkt_rx_ctrl_t)pkt->rx_ctrl;
- uint32_t timestamp = now(); //current timestamp
- uint32_t microseconds = (unsigned int)(micros() - millis() * 1000); //micro seconds offset (0 - 999)
- pcap.newPacketSerial(timestamp, microseconds, ctrl.sig_len, pkt->payload); //send packet via Serial
- }
- esp_err_t event_handler(void *ctx, system_event_t *event){ return ESP_OK; }
- //===== SETUP =====//
- void setup()
- {
- /* start Serial */
- Serial.begin(BAUD_RATE);
- delay(2000);
- Serial.println();
- Serial.println("<<START>>");
- pcap.startSerial();
- /* setup wifi */
- nvs_flash_init();
- tcpip_adapter_init();
- ESP_ERROR_CHECK( esp_event_loop_init(event_handler, NULL) );
- wifi_init_config_t cfg = WIFI_INIT_CONFIG_DEFAULT();
- ESP_ERROR_CHECK( esp_wifi_init(&cfg) );
- ESP_ERROR_CHECK( esp_wifi_set_storage(WIFI_STORAGE_RAM) );
- //ESP_ERROR_CHECK( esp_wifi_set_mode(WIFI_MODE_AP) );
- ESP_ERROR_CHECK( esp_wifi_set_mode(WIFI_MODE_NULL) );
- //ESP_ERROR_CHECK( esp_wifi_set_mode(WIFI_MODE_STA) );
- ESP_ERROR_CHECK( esp_wifi_start() );
- esp_wifi_set_promiscuous(false);
- esp_wifi_set_promiscuous_filter(&filter);
- esp_wifi_set_promiscuous_rx_cb(sniffer);
- esp_wifi_set_promiscuous(true);
- wifi_second_chan_t secondCh = (wifi_second_chan_t)NULL;
- esp_wifi_set_channel(ch,secondCh);
- }
- //===== LOOP =====//
- void loop()
- {
- /* Channel Hopping */
- if(CHANNEL_HOPPING)
- {
- unsigned long currentTime = millis();
- if(currentTime - lastChannelChange >= HOP_INTERVAL)
- {
- lastChannelChange = currentTime;
- ch++; //increase channel
- if(ch > MAX_CHANNEL) ch = 1;
- wifi_second_chan_t secondCh = (wifi_second_chan_t)NULL;
- esp_wifi_set_channel(ch,secondCh);
- }
- }
- }