I was programming esp32-s3 on Arduino IDE and it gives an error as follows, I changed the flash mode from QIO to DIO or OPI. After changing a few settings, rebooting stops but no output or working at all.
These boards was ordered in an University and it looks the boards are useless in arduino Ide
rst:0xc (RTC_SW_CPU_RST),boot:0x18 (SPI_FAST_FLASH_BOOT)
Saved PC:0x40377358
SPIWP:0xee
Octal Flash Mode Enabled
For OPI Flash, Use Default Flash Boot Mode
mode:SLOW_RD, clock div:1
load:0x3fce3808,len:0x44c
load:0x403c9700,len:0xbe8
load:0x403cc700,len:0x2a58
entry 0x403c98d4
assert failed: do_core_init startup.c:326 (flash_ret == ESP_OK)
Backtrace: 0x4037774a:0x3fceb180 0x4037a851:0x3fceb1a0 0x40380435:0x3fceb1c0 0x4200a8a6:0x3fceb2f0 0x403770b9:0x3fceb320 0x403cd777:0x3fceb350 0x403cda36:0x3fceb380 0x403c9929:0x3fceb4b0 0x40045c01:0x3fceb570 |<-CORRUPTED
ELF file SHA256: 057726d2d0fff8ce