10-bit serial at 100 kHz
Posted: Tue Jun 27, 2023 10:47 pm
I have a device that has a very non-standard serial interface. It uses something like 10-bit serial at 100 kHz.
On my logic analyzer, it looks like:
Is it possible to configure the UART to read this data format?
I'm currently trying to bitbang a solution, but I'm running into timing problems and would be much better if I could configure the UART to handle this instead.
On my logic analyzer, it looks like:
Is it possible to configure the UART to read this data format?
I'm currently trying to bitbang a solution, but I'm running into timing problems and would be much better if I could configure the UART to handle this instead.