flash read err, 1000 on ESP32-WROVER

[Jurkylius]

I have same problem but little diffrent.

rst:0x1 (POWERON_RESET),boot:0x33 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
cmd len -1
ets_main.c 371
ets Jun 8 2016 00:22:57

When I connected GPIO 12,13 and in setup set pinmode output with digitalwrite high board not working when I put power and write this error in serialport. When I start without this pin connected, power up board and after that connected this pins all work. Have you any advice for me?

[satwik]

I'm experiencing the same issue, but only some times when the module are recovering from deep sleep (the average is +/- 1/30000)
This is the error message:

rst:0x5 (DEEPSLEEP_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
flash read err, 1000
ets_main.c 371
ets Jun 8 2016 00:22:57

rst:0x7 (TG0WDT_SYS_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 188777542, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0018,len:4
load:0x3fff001c,len:672
ho 0 tail 12 room 4
load:0x40078000,len:0
load:0x40078000,len:10320
entry 0x40078ac0

Can anyone help with this issue?

please change the mode of the arduino

[Kashyapkoshti]

rst:0x10 (RTCWDT_RTC_RESET),boot:0x1f (SPI_FAST_FLASH_BOOT)
flash read err, 1000
ets_main.c 371

I am getting this error in my esp32 devkit v1
How to solve it?
I am using arduino IDE for programming the esp32.