I'm currently trying to get my ESP32 WROOM on the Devkit connected with an FT2232H FTDI Adapter. I hooked up the 4 JTAG Lines. No Reset. When I try to flash the binary via JTAG I get the following Error. Is this a common fault?
I already tried lowering the Speed from 20M to 5M.
Code: Select all
$ sudo bin/openocd -s share/openocd/scripts -f interface/ftdi/esp32_devkitj_v1.cfg -f board/esp-wroom-32.cfg -c "program_esp32 ../rainbow_esp32/build/app-template.bin 0x10000 verify exit"
Open On-Chip Debugger 0.10.0-dev-ga859564 (2017-07-24-16:16)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
none separate
adapter speed: 5000 kHz
force hard breakpoints
Info : clock speed 5000 kHz
Info : JTAG tap: esp32.cpu0 tap/device found: 0x120034e5 (mfg: 0x272 (Tensilica), part: 0x2003, ver: 0x1)
Info : JTAG tap: esp32.cpu1 tap/device found: 0x120034e5 (mfg: 0x272 (Tensilica), part: 0x2003, ver: 0x1)
Info : esp32: Debug controller was reset (pwrstat=0x40, after clear 0x40).
Info : esp32: Core was reset (pwrstat=0x5F, after clear 0x0F).
Info : JTAG tap: esp32.cpu0 tap/device found: 0x120034e5 (mfg: 0x272 (Tensilica), part: 0x2003, ver: 0x1)
Info : JTAG tap: esp32.cpu1 tap/device found: 0x120034e5 (mfg: 0x272 (Tensilica), part: 0x2003, ver: 0x1)
Info : Target halted. PRO_CPU: PC=0x400067E7 (active) APP_CPU: PC=0x00000000
esp32: target state: halted
Info : esp32: Debug controller was reset (pwrstat=0x5F, after clear 0x0F).
Info : esp32: Core was reset (pwrstat=0x5F, after clear 0x0F).
Info : Target halted. PRO_CPU: PC=0x5000004B (active) APP_CPU: PC=0x00000000
esp32: target state: halted
Info : esp32: Core was reset (pwrstat=0x1F, after clear 0x0F).
Info : Target halted. PRO_CPU: PC=0x40000400 (active) APP_CPU: PC=0x00000000
esp32: target state: halted
** Programming Started **
auto erase enabled
Info : Use core0 of target 'esp32'
Info : Target halted. PRO_CPU: PC=0x40091CF8 (active) APP_CPU: PC=0x00000000
Info : Auto-detected flash size 3408150 KB
Info : Using flash size 3408150 KB
Info : Use core0 of target 'esp32'
Info : Target halted. PRO_CPU: PC=0x40091CF8 (active) APP_CPU: PC=0x00000000
Error: Failed to erase flash (3)!
Error: failed erasing sectors 16 to 129
** Programming Failed **
shutdown command invoked