How to pause ADC Continuous Mode reads ?

[nomaski]

Hi - I would like to pause ADC reads into DMA for 100 microseconds or so during an I2C peripheral read due I2C clock noise that's showing up on the ADC signal .. and then re-enable the reads after the I2C transfer is complete.

So I'm essentially looking to create adc_continuous_pause/resume() functions .. something like:

Code: [Select all] [Expand/Collapse]

1. esp_err_t adc_continuous_pause(adc_continuous_handle_t handle) {
2.  
3.     // Stop ADC hardware without deinitializing
4.     adc_hal_digi_stop(&handle->hal);
5.  
6.     // Disable ADC end of conversion interrupt
7.     adc_hal_digi_dis_intr(&handle->hal, ADC_HAL_DMA_INTR_MASK);
8.  
9.     return ESP_OK;
10. }

GeSHi © Codebox Plus Extension

And then:

Code: [Select all] [Expand/Collapse]

1. esp_err_t adc_continuous_resume(adc_continuous_handle_t handle) {
2.     if (handle == NULL || handle->fsm != ADC_FSM_PAUSED) {  // Assuming FSM_PAUSED state is added
3.         return ESP_ERR_INVALID_STATE;
4.     }
5.  
6.     // Re-enable ADC end of conversion interrupt
7.     adc_hal_digi_en_intr(&handle->hal, ADC_HAL_DMA_INTR_MASK);
8.  
9.     // Start ADC hardware without reinitializing
10.     adc_hal_digi_start(&handle->hal);
11.  
12.     return ESP_OK;
13. }

GeSHi © Codebox Plus Extension

Any thoughts/ideas suggestions on this approach??

thanks!