WROVER-E flash programming before sending to the factory
Posted: Tue Jun 14, 2022 5:59 pm
Dear Espressif Team
I am designing a custom board using a WROVER-E module, and I need to produce 200 boards. Due du component shortage in general, I have already purchased 200 WROVER-Modules.
I would like to be able to flash them by myself before sending them to the factory, so that they can easily test the boards without need to flash the firmware.
Is there a tool that I could use for flashing the WROVER-E modules before sending them at factory ?
Many thanks
Thierry
I am designing a custom board using a WROVER-E module, and I need to produce 200 boards. Due du component shortage in general, I have already purchased 200 WROVER-Modules.
I would like to be able to flash them by myself before sending them to the factory, so that they can easily test the boards without need to flash the firmware.
Is there a tool that I could use for flashing the WROVER-E modules before sending them at factory ?
Many thanks
Thierry