Button connection and wind speed measurement (pullUP or pullDOWN)
Posted: Thu Jul 22, 2021 12:01 pm
Hello,
I am currently working on the wiring diagram for restart, HIGH button and interrupt wind speed measurement. For those buttons, a 10K resistor together with a 100nF capacitor is enough. For wind speeds I will use a resistance lower than 1K. I want to ask if I'm right. I'm basically doing this for the first time.
I will be very happy for help from skillful craftsmen.
But what I find out is that the parallel connection of the capacitor with the button is wrong. The capacitor is shorted. So which scheme will be correct?
THIS?
I am currently working on the wiring diagram for restart, HIGH button and interrupt wind speed measurement. For those buttons, a 10K resistor together with a 100nF capacitor is enough. For wind speeds I will use a resistance lower than 1K. I want to ask if I'm right. I'm basically doing this for the first time.
I will be very happy for help from skillful craftsmen.
- schema.jpg (32.53 KiB) Viewed 2519 times
THIS?
- schematic_new.jpg (47.98 KiB) Viewed 2519 times