Have to Press "EN" To Start Custom Board
-
- Posts: 12
- Joined: Fri Mar 12, 2021 1:37 pm
Re: Have to Press "EN" To Start Custom Board
Hello I am having the exact same problem does anybody found a solution for this (except leaving out the one cap)?
Re: Have to Press "EN" To Start Custom Board
Hello, could you send your schematic for us to check?
Re: Have to Press "EN" To Start Custom Board
Hello, I have received your schematic.
I think what cap you mentioned in " leaving out a cap " is C3, so as you know, we should set GPIO0 at high before chip is enbaled, now cap at GPIO0 slows down the rising of high level, we could only decrease the enable speed.
Anyway, I think removing C3 is better.
I think what cap you mentioned in " leaving out a cap " is C3, so as you know, we should set GPIO0 at high before chip is enbaled, now cap at GPIO0 slows down the rising of high level, we could only decrease the enable speed.
Anyway, I think removing C3 is better.
Re: Have to Press "EN" To Start Custom Board
Hello, I have exactly the same problem with my custom board. All features are ok, but the board doesn’t start without a press on the EN Button.
I’ve started a topic on this problem on june with my schematic and I’ve checked all the pins.
Any help will be appreciated. The link on my initial post is : viewtopic.php?f=12&t=21271#p77644
Thank you in advance.
I’ve started a topic on this problem on june with my schematic and I’ve checked all the pins.
Any help will be appreciated. The link on my initial post is : viewtopic.php?f=12&t=21271#p77644
Thank you in advance.
Who is online
Users browsing this forum: No registered users and 31 guests