Hi there,
for a battery powered solution, I want to switch from a ESP32 dev board (DOIT Devkit V1, 30 GPIO) so a bare ESP32 to save power.
Because I don't want to rebuild the entire hardware (there is a PCB with all sensors and I can stack DevKit V1 on it), I'm looking for a bare PCB which provides the same pinout as for common Development boards but without USB, LED, cheap LDOs and all this stuff which draws my batteries to dead.
So does anyone know a bare board with the same pinout of common development boards?
Patrick
bare PCB with common pinout of Devkit V1
Re: bare PCB with common pinout of Devkit V1
I don't know of a board like that. But why not just remove the IC's off the board you already have.
Who is online
Users browsing this forum: No registered users and 74 guests