@kolban
thank you for your help! I had already given up hope for an answer and therefore did not check regularly. As suggested, it should work.
Regards

I want to use the pulse counter (PCNT) of the ESP32 to count pulses arriving at its input. Is there a way to extend the measurement range to more than the 16 bit countable 65535 pulses, because more than 65535 pulses will arrive in one measurement pass? I googled for the keywords »PCNT Overflow Rang...

Thanks for the fast answer! To point 5: Just after sending my issue, I recognized my mistake: In my sketch, all values were output hexadecimal via the serial monitor, with the exception of chip info features , which was decimal and 0x32 = 50! To point 4: Here is the relevant code snippet: Serial.pri...

I've tried to read the parameters of my recently purchased ESP32 in two different ways in the Arduino IDE: 1. Using class ESP 2. Using the function esp_chip_info(esp_chip_info_t * out_info) [see below] The following readout data was displayed from the Serial Monitor of the Arduino IDE (points in que...