Any thoughts? It must be something pretty simple I'm missing; I'm using the example unchanged.

Hi, I'm trying to get my SD card up and running. I have it set for SPI mode. I have a microSD breakout board from "WaveShare" that has 10K pullup resistors on all of the pins, save ground. I've wired it to the default GPIO pins from the example program, but when I run the monitor I get the following...

Well, you are right...setting that global fixed it. I'd still be interested in learning what the step I need to take is to pull in the values from menuconfig, perhaps Rudi can chime in at some point.

I think you are missing what I put in the post above yours? I don't think that's it. As I said, I set it up to use the esp-idf as Rudy described in his response to you on page 7. I am able to turn on the CAN module, set the pins and the speed all from the menuconfig. So that part seems to be workin...

I'm still trying to get this code to work. I decided to add the third party components as Rudy suggested. That seems to be working great and I can turn on CAN and configure it in the menuconfig. I took an example project that I had running on the chip (simply blinks the LED) and tried to just add th...

Great work everyone in this thread. I'm brand new to all of this, so this is probably a stupid question. I've never done any programming in the ESP-IDF environment and I'm not a particularly experienced programmer in general. I got myself a development board (Geekworm ESP32-C1) and spent the morning...