Have you checked your partition table is suitable for the app with Bluetooth installed? Hi Steve, thanks for your reply. Yes, I have already increased te app partition size. The firmware image fits in. It appears to be a problem with ram resources being short. It also isn't connected to Bluetooth. ...

Hello, our project is rather larger. It includes BT and WiFi and external SPI-RAM. At this point (after adding a lot of code) it crashes after the bootloader (with Bluetooth included in Firmware). When removing Bluetooth, everything works as expected. Our Bluetooth driver code itself is working corr...

Hello WiFive,

thank you very much!

Best Regards, Timm

Hello, we are going to sell a product which includes an esp32 with bluetooth/ble functionality. I have two questions, which hopefully someone can answer: (1) Regarding bluetooth ceritifcation and qualification, which steps are required to sell this product? (2) Can the bluetooth logo be used on the ...

Thanks!

Hello, when I start up the esp32, I see text on the debug uart (see below). This is before the green debug output starts. How can this be removed? (using this uart for a serial bus) Greetings, Timm ets Jun 8 2016 00:22:57 rst:0x3 (SW_RESET),boot:0x1b (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee cl...

Hello everybody, how can I add support for the idf spi-driver into bootloader? I have a spi-sd-card driver (which already works in firmware) which I want to use in the bootloader. I have added a custom bootloader into a project called "bldr". Copied from /esp-idf/components/bootloader into my projec...

Hello,

I have the requirement to transfer files to the esp32.
Preferably using wifi and ftp.

Is there a ftp component for the esp32?
What other means of transport are reasonable and available?

Thanks for any input

BR Timm

Hello, I want to connect an external SPI-flash to SPI2 or SPI3 of wrover -module (not SPI1 as it's used for on-chip ext_ram/ext_flash). The example "ext_flash_fatfs" exactly covers this scenario. It starts up successfully (spi_bus_initialize() and spi_bus_add_flash_device() succeed). But fails at re...

Hello, I am trying to measure the ESP32 supply voltage (VDD33) using ADC2. From the ref. manual p565, I figured out to set bit SENS_SAR2_EN_TEST in register SENS_SAR_START_FORCE_REG. I did these steps: configured attenuation for adc2 channel 7 to 6dB set bit SENS_SAR2_EN_TEST in register SENS_SAR_ST...