ALL uC's have similar documentation:
https://docs.espressif.com/projects/esp ... s/adc.html

The ADC is essentially "free" and satisfactory for Arduino projects.

... #3. Produced all expected output: message from setup() and then repeating messages from loop() Then I recalled a video on youtube from a "guy with a Swiss accent" - Introduction into ESP32 (#147) and at 10:39 he speaks about "typical" instability. Do I observe the same typical instability, rela...

... I am planning to use this MQTT protocol but my question is can MQTT protocol handle over than 100 of ESP32 to communicate with one server and each of this send every 1 sec ? ? ... The server will be installed on raspberry pi or windows 10 pc and store incoming data on SQLite database . It would...

In your ArduinoIDE/preferences, ensure you have the correct JSON listed:

https://github.com/espressif/arduino-es ... manager.md

Then using the IDE board manager, select the ESP32 official install. You may wish to uninstall first and then do a clean install.

... Now, is there a way to send the raw data from pin 4 to an artificially created pin - say, pin 36 - such that you could run the same program from above? The only deference being the program references pin 36 instead of pin 4 for turning on the LED. ... Arduino is messy, look at any hw variant fi...

... I need wired connection. Serial/TwoWire usually loses data/reads with 0s or other charrecters. I don know whats your application, I usually use interrupt timers and haw "Reach Slave Device" code to ready changes in a loop. Tested many things and does not always work (usually 85% of packets arri...

I have only gotten two to work fully previously: My example here is for ILI9341, HSPI & VSPI Maybe you can use your approach to get 2 on each hardware SPI interfaces. https://www.hackster.io/rayburne/dual-display-on-esp32-4c75b5 https://hackster.imgix.net/uploads/attachments/1193077/esp32-vspi-hsip_...

Interesting. Clearly, the Arduino syntax for pinMode() shows "INPUT_PULLUP" the Espressif syntax seems to suggest "INPUT" and "PULLUP" are two separate commands: https://github.com/espressif/arduino-esp32/blob/3fc974f3aac37da42fedc7c1ddae1e1a63579378/cores/esp32/esp32-hal-gpio.c Of course, perhaps t...

If you use Arduino, you will overwrite Python and will have to use the Espressif flash tool to reload the Python binary interpreter.