I found this https://esp32.com/viewtopic.php?t=8704
My Problem is the Part I have to press Reset and Boot then you have to release Reset and then Boot then it works

Hello I have a ESP32 Himalaya Board and I tried everything. I drive IO0 to Ground I let GPIO2 float I drove it down to GND I use an External 3V3 nothing When I push Reset I get mode:DIO, clock div:2 load:0x3fff0008,len:8 load:0x3fff0010,len:3480 load:0x40078000,len:7804 ho 0 tail 12 room 4 load:0x40...

Thank you very much !!!!!

Hallo
How can I switch on the PullUp- PullDown Resistors in the Arduino IDE

I don't have any Problems with the AMS 3.3 maybe you have a wrong resistor or broken C

Hello is it possible that the Camera and the LCD work together, because the LCD and the Camera share the same GPIO18 and GPIO19 .
Why on earth to they have the same GPIOs. Have a happy 2019. By the way I love the ESP32. I bought me in the USA 3 of this great boards but now I'm a bit sad

Hello ESP32 Community Can someone tell me why this code does not run #include "SPI.h" #include "Adafruit_GFX.h" #include "WROVER_KIT_LCD.h" #define min(X, Y) (((X) < (Y)) ? (X) : (Y)) WROVER_KIT_LCD tft; void setup() { Serial.begin(115200); tft.begin(); tft.setRotation(1); uint8_t x = 0; uint32_t id...

Thank you that is what I thought.
What a pain in the ass, I'm on vacation and have to use this stupid Power Supply

Hello ESP32 Espressif friends I fiddle with my new ESP-WROVER-KIT 4.1. I like it and I didn't had a Problem without WiFi. With WiFi I need the 5V Power Supply but when I change the Jumper the UART Port is not working. What does I have to do, to make it work with the Com Port and Power Supply. Can I ...

I found this
https://github.com/espressif/WROVER_KIT_LCD
Perhaps it's helpful