I started getting watchdog timer reset for this code too: extern "C" void app_main() { initArduino(); // This code will go away in non test mode. Serial.begin(115200); for (;;) { Serial.println(touchRead(T0)); delay(100); } } But it stopped coming as soon as I split it into setup and loop. I looked ...

I'm getting similar error: https://esp32.com/viewtopic.php?f=19&t=3019. But it works fine when I use older version of esp32 arduino library.

Hi, I'm getting the following error continuously in the latest esp32 arduino master. rst:0x7 (TG0WDT_SYS_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO I've attached the full serial output. The code wor...

I'm using ESP32 doit devkit v1. It does not even expose GPIO0 pin in the breakout board. And the pin2 is connected to an led, which means I cannot use that too. I'm stuck with only 8 pins . Bought quite a few of those boards already.

Thanks Franco. The design doc for capacitive sensor design would be much appreciated.

Hi, I tried using esp32 touch sensors and have a few problems. I tried following the instructions in the esp32 datasheet: Appendix A - Touch Sensor. The diagram shows a capacitor b/w ground and esp32 pin. But as soon as I add a capacitor the system immediately registers a touch? Is there any documen...

nghttp2 does not seem to work out of the box on ESP32-Arduino. I tried compiling the nghttp2-ssl example and got the following error. In file included from /Users/user1/Documents/Arduino/hardware/espressif/esp32/tools/sdk/include/nghttp/nghttp2/asio_http2_server.h:28:0, from sketch/web_server.h:4, f...