Any help???

Thank you! I'm doing that from like here: https://github.com/espressif/arduino-es ... windows.md
section "How to update to the latest code"?

or is there any other process?

Any help?

Hello!

I was trying to play a little bit with the ESPNow examples from here: https://github.com/espressif/arduino-es ... les/ESPNow

but when I'm trying to compile the examples I'm getting esp_now.h can found...

Any help?

Thanks kolban! It was very helpful

By reading the ESP32 datasheet I figure that every single IO pin can be configured with a pull up or pull down resistor. Is this correct or I missing something here? Also, can I somehow configure some gpio pins with interrupts? I'm using Arduino for ESP32 programming and I want to do interrupts like...

I'm a newbie with the ESP32 and I have a few question about multicore programming with arduino! By reading this post I understand that I can use the two cores only by using the FreeRTOS. Is this correct? Can somehow program the chip to something like void setup1() void loop1() void setup2() void loo...

Thank you sintech!!!
It was really helpfull!

loboris wrote:If you want to use Arduino, follow the Arduino instructions

Ok, I will! Thanks loboris!

loboris wrote:It is not possible to run ESP32 firmware code from SD card.

Can at least write a .hex file or .bin file or something to the SD card and flash the ESP32 from the SD card?

Thanks alot to everyone of you! Another simple question! I want to connect an SD card to the ESP. I am using the Arduino core. It seems that they are using those connections to connect the sd card: https://github.com/espressif/arduino-esp32/tree/master/libraries/SD But on the ESP Wroom 32 datasheet ...