ESP-IDF function esp_wifi_get_inactive_time() is found in esp_wifi.h, but code below won't compile in Arduino IDE 1.8.13 due to 'esp_wifi_get_inactive_time' was not declared in this scope other functions in esp_wifi.h e.g. esp_wifi_set_bandwidth() are fine. Checked spelling, conflicts, etc & I can't...

Ouch! Without external radio coexistence interface control, my hopes appear to be dashed. I considered using WIFI_OFF to turn off all Wi-Fi transmission (any pending tx on the lower layer, IP stack, etc) until I had fresh sensor data to send. Disconnecting-reconnecting WiFi, however, is messy and in...

Thanks WiFive. The FCC statement for ESP32 says The antenna(s) used for this device must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located with any other transmitters, except in accordance with FCC multi-transmitter product procedures. TX2's ...

My product incorporates an ESP32 transmitting UDP Wi-Fi (BT is off) and a second co-colocated transmitter TX2 with functions TX2_ON() & TX2_OFF() that turn TX2 transmission on/off immediately. Now to avoid major $$$ FCC co-location testing, I must insure that both transmitters are mutually dependent...

I've contacted sales, but I am still awaiting additional information.

My device incorporating an ESP-WROOM-32 module has initially failed FCC Part 15 Unintentional Radiator Testing. Spurious emissions at the second harmonic are significantly higher than Espressif's original FCC test report and out of tolerance. Espressif's FCC test report (pg 7) says "The worst condit...

That's helpful! Is there any official guidance?

My end product prepped for resale is a Motion Detector (DT100) interfaced to an ESP-WROOM-32 module. The ESP-WROOM-32 simply takes data from the DT100 RJ45 RX/TX pin-out via Serial-to-TTL and then transmits via Wi-Fi. Other than that connection and sharing 5V power across CAT5, the modules are uncha...

My prototype with Sparkfun ESP32 thing seems to have room for TCP/UDP improvement and Sparkfun tech support had no info.

So, any update on this issue concerning Sparkfun ESP32 thing or other boards such as Adafruit Huzzah32 or WEMOS LoLin32?

btw I'm using the Arduino IDE not ESP-IDF.

Thanks.

I've replicated the ESP32 Web Radio project by MrBuddyCasino using an ESP32 Dev Board and Adafruit MAX98357A Breakout #3006 such that continuous music streamed from my Android phone to ESP_SPEAKER sounds fine. My issue, however, is that short, intermittent sound clips from the phone are initially so...