Hi all

i am working with bluetooth in ESP32, i used the gatt_server example code in esp32, i am able to connect one client at a time, but when i am trying to connect multiple client connection is not happening.

Is that possible to connect multiple ble client with a ble server in esp32 ?


Amal Lal

Hi All

Anyone interfaced the accelerometer LSM6DS3 with esp32?

or anyone worked with it please tell the procedure to work with it.


Thanks

Hi I tried the example "wear_levelling" in esp32 to store some data in the SPI flash, for working with this example we changed the partition type to csv and made a partition "partitions_example.csv" and it is working, writing and reading in spi flash happening. But i need to work with OTA also same ...

Hi all

I am using the ota example code in esp32, it is working fine with a local http server, But after one updation through ota i am unable to flash code through eclipse setup,if i flash also the old code only running. Anyone knows the solution please let me know.

Thanks,
Amal

Hi

I am trying to interface OV7670 camera with esp32, Is there any driver available for this camera with esp32?


Thanks

Thanks for the replay sir

I tried the way as you said, changed the event_handler .But still the same issue coming " wifi: bcn_timout,ap_probe_send_start". Please tell any other suggestion you know to fix it.

Thanks

Hi I am trying to push some data to sever by http over wifi, but after sending 30-40 minutes it showing the error "wifi: bcn_timout,ap_probe_send_start " , Wifi is disconnecting and trying to connect again, it will connect and show the same error and disconnect. Please help me fix this issue. Please...

Hi ESP_igrr

Thanks for the reply, I changed the slote 1 to slote 0 in sdmmc_host_t structure .

As per your suggestion
" It is only possible to use SDMMC on these pins if SPI flash is assigned to other pins"

could you please tell me how to assign the SPI flash to other pins?

Thanks

Hi

Anyone have the driver for SD card with SDIO protocol with a pinout of GPIO6,7,8,9,10,11


Thanks

Hi I attached one gps module output with uart 1 rx_pin and received data in one buffer and printing it through uart 0, But it is giving an error "Guru Meditation Error of type Illegal Instruction occurred on core 0. Exception was unhandled", I am attaching the error i am getting and code here , plea...