Hi,
I'm experiencing the exact same issue in ESP-AT 3.2.0.0
any tips?
Best Regards!
Search found 4 matches
- Fri Apr 26, 2024 9:17 am
- Forum: ESP-AT
- Topic: BLE-AT- spp - Service uuid 0xA002--> Write Char uuid 0xC304 sending 1 byte only (from nrfconnect)
- Replies: 3
- Views: 7658
- Thu Nov 03, 2022 7:35 am
- Forum: ESP-AT
- Topic: ESP-AT Abort Serial Data transfer (after '>' character)
- Replies: 4
- Views: 4770
Re: ESP-AT Abort Serial Data transfer (after '>' character)
Hi, I'll probably go with #2. I wanted to prevent that because my free memory is pretty low and this will involve reading the file beforehand and storing the data to send, but I guess that's the way to go. Building the HTTP POST on my side will be more complex and will spend even more memory, so tha...
- Wed Oct 26, 2022 5:40 am
- Forum: ESP-AT
- Topic: ESP-AT Abort Serial Data transfer (after '>' character)
- Replies: 4
- Views: 4770
Re: ESP-AT Abort Serial Data transfer (after '>' character)
Hi, I'm just using HTTP Post to send some data to a Host for processing. Data is stored on a file. I experienced some errors when accessing the data that left the ESP32 blocked due to lack of data. Of course I could just send 0 until I reach the limit, but that would just send garbage to the server ...
- Mon Oct 24, 2022 8:39 am
- Forum: ESP-AT
- Topic: ESP-AT Abort Serial Data transfer (after '>' character)
- Replies: 4
- Views: 4770
ESP-AT Abort Serial Data transfer (after '>' character)
Hi, I'm using the ESP-AT firmware on an ESP32 chip. I'm unable to find any method to cancel/abort the serial data transfer after getting the usual '>' character This is used in commands like AT+HTTPCPOST or AT+BLEGATTSNTFY. Sometimes an error might be detected after starting the direct data transfer...