Thank you for this help, lol. The reason for the error was a wrongly set Reset_pin to the W5500. The reset pin wasn't even connected in the setup. We set it to 35 which should not really have mattered (or at least prompted an error). This led to the driver install function triggering the watchdog i ...

I just saw that i never replied.

Thank you. It worked.

CHIP: ESP32S3 ESP-IDF Hi, I know this probably would have been better off in the issue page, but at this point im not aware if maybe there is a good reason for it. When initializing the W5500 it works fine, as long as the SPI communication is stable. The moment the SPI communication does not work, (...

Good Morning, today me and my colleague tried to use the Espressif VsCode Extension, to try and build, flash etc. our project. However, since today, not a single Button within the VsCode Extension works. We both use seperate installations of VSCode and Esp-IDF we installed it the recommended way des...

Hi i have a problem, i have 2 components. "ComponentA" controls pin output. It defines functions for this. The idea is,that the other component "ComponentB" calls this function and can set the pins. ComponentB needs these functions. They call the componentA_function in its own functions. So i includ...

thanks for that honest and comprehensive answer.

Thanks again for the help, and i hope you will have a nice rest of the week.

Thank you a lot,
replacing the interrupt flag did solve the problem. Maybe a error code could be added to the IDF.


Is there a better documentation regarding the use and limits of these Interrupt flags? I could not really conclude the requirements out of the comments in the code.

Thanks for the timely reply. I tested the 2 SPI Devices on 2 Busses in an isolated environment and it worked just fine. I then retested it within my setup&test function and it stopped working again. I then disabled the modules one by one, observing wether the bug stops occuring if i do not initializ...

We are developing a System in which 5 SPI Slaves are connected to the ESP32-S3. For that we intend to use the SPI2_HOST and SPI3_HOST. SPI2 will have 2 slave devices connected and SPI3 3 slave devices. For this test only one slave is connected to each bus. Initializing the busses independently, the ...