Thanks

Hello,

1. How to switch the usb otg speed from full speed to low speed?
2. esp32s3's USB only support OTG, but in the pinout there is no usb id pin, why? I want to use USB ID pin to determine esp32s3 role. How to solve it?

Thanks

username wrote: ↑

Fri Oct 13, 2023 6:58 am

How in the world are you able to sell that for $25!!!

, Yes, It values 25USD!

Amnos MIO Breakout is designed for beginers by XPU Labs, a subsidiary of AnalogLamb.Com. It integrates 8 digital 7-segment LEDs, TFT LCD, WS2812, RTC, FLASH, EEPROM, SD Card Connector, Speaker Driver, Microphone, ADC/GPIO Keys, LEDs, RS485, CANFD Transceiver, Accelerator Sensor, DS18B20 and so on. U...

Thanks. We will update the breakout boards. Breakout is development board

This is not the schematics of the board I've got with ALB32-WROVER. It is a simple breakout board, with no active components and no pull-up resistors . http://loboris.eu/ESP32/Breakout-top.jpg http://loboris.eu/ESP32/Breakout-bottom.jpg Yes, You are right. There is no resistor. It is a breakout for...

Hi,

Thanks. It is on bottom side of boards. Here is the sch. Thanks
https://github.com/AnalogLamb/esp32/blo ... eakout.pdf

ESP32-WROVER is a New module for powerful application.

Recently I got the Esp32-PICO-D4 chip. It is a SIP, all esp32 modules components are included in a single ESP32-PICO-D4 chip.
OK Have look at it.