I'm trying to write some robust code that looks for another access point when the current one disappears. So far (in pseudocode) I do esp_wifi_set_config(...) esp_wifi_connect() //AP I'm trying to connect to isn't available... //I wait until I see the callback for a SYSTEM_EVENT_STA_DISCONNECTED eve...

Hello again.

If there's no definitive answer, can anyone provide the reasons behind the recommendation of not soldering the ground pad in the datasheet?

Thanks

Just bumping this again, not sure if it got noticed first time. 1. a means so that peripherals can communicate with each other without waking the main core. With the ULP available this probably makes sense to use that. Think of it as DMA for interrupts! 2. A configurable logic block on some (or all)...

Yes, I got the message back when I emailed Espressif directly.

I just wanted to check the reply emails hadn't been modified/intercepted as the reply didn't come back from Espressif, so wanted to check if other people had also received orders!
Thanks

I'm in the process of buying so ESP parts for a product we're building and I have been asked to place the order with Schtoeta Engineering Limited which apparently handles the export. Before I transfer a significant amount of money, can I check it is legit?

Thanks

We're about to send a PCB off, so if we could get an official answer on this it would be really useful please? (I know you must be busy at Espressif). If not, could you share the reasoning for the data sheet saying not connecting it/pasting it -- so we can best design to ground (or not ground) it, t...

Can you physically disconnect the LEDs and try running the same code? That way you know if it's noise/browning out of the power supply?

Answering my own problem, I found that the difference between the USB->UARTs was how they handled a block of characters sent in sequence (so probably something related to buffering in them). My advice to others would be to loop back TX to RX and then compare what esptool was was trying to send, to w...

I've changed USB->UART convertor and now things work. I'd still like to work out why the other convertor did not work, so would still welcome suggestions as to where the error comes from.
THanks

I'm having problems too. I'm using a custom circuit, and I have a 500mA reg and have tried it with a bench power supply. When trying to flash or read_flash_status I get Chip is ESP32D0WDQ6 (revision 0) Uploading Stub... A fatal error occurred: Failed to write to target RAM (result was 01070000) UART...