Description: If power is given to device from laptop, ADC point is stable but if using power adaptor or other dc power source at same voltage reading ADC point fluctuation is detected.  ADC points are read using adc1_get_raw(). Yes, I am having the same issue. I have configure the ADC1_CH6 as 12 bi...

Yes!
That's solved my problem.. Thank you

FYI. Calibration fuses: BLK3_PART_RESERVE (BLOCK0): BLOCK3 partially served for ADC calibration data = False R/W (0b0) ADC_VREF (BLOCK0): Voltage reference calibration = 1058 R/- (0b10110) Config fuses: XPD_SDIO_FORCE (BLOCK0): Ignore MTDI pin (GPIO12) for VDD_SDIO on reset = False R/W (0b0) XPD_SDI...

Hello, Yes, I am following the steps as mentioned. But still the counter is incremented in odd number. You can see this in below logs. Connecting...... Detecting chip type... Unsupported detection protocol, switching and trying again... Connecting.... Detecting chip type... ESP32 espefuse.py v3.3-de...

If you had enabled flash encryption in "Development" mode then it should be possible to disable it (based on value of FLASH_CRYPT_CNT field). Please refer to documentation at https://docs.espressif.com/projects/esp-idf/en/latest/esp32/security/flash-encryption.html#disabling-flash-encryption for de...

Hello,

I have enabled the Secure boot V2 + flash encryption in my code.. I want to disable the flash encryption in EPS32. Can anyone provide the proper steps for Disable the Flash encryption?

Thanks In Advance,
Jainam Shah

Hello,
I am working on the OTA-based firmware update... I want to authenticate the sender at the ESP32 end. Do we have any examples related to that?
Kindly help me with this...

Yes

Hello, I am working on the update using OTA. I have experienced a problem with my application. After downloading and restarting, my application hangs in the OTA partition. I have attached the console logs here. I (29) boot: ESP-IDF v4.3-dirty 2nd stage bootloader I (29) boot: compile time 10:16:50 I...

When I am printing the logs in any emulator, Pressing the button connects the ground to the 0th pin. Unfortunately, the GPIO0 is in the active low state so the functionality of the button is stopped. Also, I have tried both cases when DSR\DTR is set and not set. I am using ESP32-WROOM-32D version-4 ...