I also need to stop the fading immediately, there is no ledc_fade_stop function in idf v4.4.1.

I have the same issue. After "TS_DECODER: Error ts packet sync, line:111 ....." it stall with the player status in playing state. It does not read the next ts stream or continue to read the hls playlist, it just stop there.

Colman

I have not tested with iperf. For the problem above, I have found out the cause, it is due to the CS setup timing to small when running the spi clock at 40MHz. After I set the clock back to 20MHz, it works fine. Since DM9051 support 100Mbps, and it can run at 50MHz clock, I want the spi bus speed to...

I am use IDF version 4.4, I have a problem in using DM9051 SPI ethernet controller. The "RX Memory Overflow Error" of "RX Status Register" is set frequently, and sometimes it reports "last transmit still in progress, cannot send." I try to force it to run 10Mbps only, but the error still happens. Do...

I have the same issue, I want to know how to stop a running ULP.

Colman

ESP32's I2S interface has problem in slave mode. It use its internal clock to clock the state machine, when the internal clock is faster than the mclk, it will cause I2S FIFO underrun. So, you must use the codec as slave and ESP32 as master.

Colman

V3.6.2.2 cannot run on my Windows, attached is the console error message.

Does esp32 idf support light sleep mode? The compiler reports error as below: error: implicit declaration of function 'esp_sleep_enable_timer_wakeup' [-Werror=implicit-function-declaration] esp_sleep_enable_timer_wakeup(1000000); ^ error: implicit declaration of function 'esp_light_sleep_start' [-We...

I am using a custom made board with 4Mbyte pSRAM, similar to the WROVER module.

Colman

Sometime it output:

W (25539) wifi: tx rts error 0x17

E (25540) wifi: lmac.c lmacProcessTxRtsError 1608

Task watchdog got triggered. The following tasks did not feed the watchdog in time:
Tasks currently running:
CPU 0: wifi

What is it? How to avoid it?

Colman