Thank you for your reply.
Search found 3 matches
- Fri Apr 16, 2021 3:22 pm
- Forum: ESP-IDF
- Topic: Can't get IP address using ethernet/basic example with Olimex ESP32-PoE (Rev. B)
- Replies: 3
- Views: 4763
Re: Can't get IP address using ethernet/basic example with Olimex ESP32-PoE (Rev. B)
Ehmmm, I feel so embarrassed, beginner's mistake... I had a board connected to the laptop - not to the router.
Thank you for your reply.
Thank you for your reply.
- Wed Apr 07, 2021 9:13 am
- Forum: ESP-IDF
- Topic: Can't get IP address using ethernet/basic example with Olimex ESP32-PoE (Rev. B)
- Replies: 3
- Views: 4763
Can't get IP address using ethernet/basic example with Olimex ESP32-PoE (Rev. B)
Hi, I am using OS Win10, VS Code EPS-IDF extension (all actually updated versions) and Olimex ESP32-PoE (Rev. B) board, and I am struggling with getting IP address using ethernet/basic example. I configured the project as follows: sdkconfig: (Example and Ethernet Config) # # Example Configuration # ...
- Sun Mar 28, 2021 9:38 am
- Forum: ESP-IDF
- Topic: GDB cannot open serial ports accessed as COMx, can not get IP address using ethernet example
- Replies: 3
- Views: 7616
GDB cannot open serial ports accessed as COMx, can not get IP address using ethernet example
Hi, I am using OS Win10, VS Code EPS-IDF extension and Olimex ESP32-PoE (Rev. B) board, and struggling with these two problems. The first is, that when I flash the ethernet-basic example code from ESP-IDF folder (where I defined power pin for Eth PHY), I get this warning: GDB cannot open serial port...