This thread can be closed.
Adding "--encrypted" option while reflashing bootloader, appliciaton and partition table resolved the issue.

Platform: ESP32 LYRATD SYNS V1.3 ESP IDF: ESP IDF 4.0 I enabled Secure boot and Flash encyption using following options in menuconfig: Bootloader Config -> Bootloader log verbosity-> Info Security Features-> Enable hardware secure boot in bootloader-> Selected Secure bootloader mode -> Reflashable S...

How did yo solve it. I am getting the same error

BT_APPL: bta_dm_config_eir, malloc failed.

Hi ESP_Angus Thanks for quick reply. Just to double check, you didn't flash anything else after flashing the bootloader+digest binary - you immediately tried to boot the ESP32? (This is correct, just checking nothing else was written to flash afterwards.) That is correct. I did not flash anything af...

Hi ESP_Angus I executed the commands suggested by you however I still have the same problem. rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:1 load:0x3fff0018,len:4 load:0x3ff...

Any update?

Can someone help on recovering the board and point the mistake that I made.

Can anyone pleaase help? @WiFive @ESP_Angus

Platform: ESP32 WROVER(ESP32D0WDQ5 (revision 1)) ESP IDF: ESP IDF 4.0 I enabled Secure boot and Flash encyptio n using following options in menuconfig: Enable hardware secure boot in bootloader-> Enabled Secure bootloader mode -> Reflashable Sign binaries during build --> Not selected Secure boot pu...

I plan to use Bleutooth GATT over Classic (BR/EDR) channel on ESP32-WROVER-B. I am using espidf 4.0.
I noticed that code for GATT overe Classic channel is under CLASSIC_BT_GATT_INCLUDED flag.
I could not figure out how to enable CLASSIC_BT_GATT_INCLUDED using "menuconfig" , any suggestions?