Hi, I developed a custom board based on ESP32-WROOM-32D and our software had been freezed for a while after working successfully for two years. Now I decided to update it to the last ESP-IDF available. I am doing it step by step so first of all I am trying with ESP-IDF 4.1 but unfortunately I am fac...

I don't see an actual "error" message in any of those outputs. Is the displayed app version correct? Is that all that is displayed? What happens afterwards? Does the ESP32 just hang, or does it continue rebooting and displaying those same messages? Your partition table appears to be Ok, as far as I...

I will keep on replying to myself :D I connected the debug serial port and this is what I see. As far as I understand it seems I am using part of the reserved memory? How is that possible? Does anything change between 4.0.1 and 4.1? By the way, I am using flash encyrption and this is my partition ta...

I tried to go step by step so I downgraded to esp-idf 4.1 but it does not work either. The error is the following: rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:2 load:0...

Hi, we developed some years ago a product based on ESP32-WROOM_32D, initially using ESP-IDF 4.0.1. It has been working successfully until now. We have initiated a migration process aimed at ESP-IDF 4.4.3 (last stable release). After changing everything related to tcpip_adapter and solving an issue d...

Hi, the initial versions of my firmware were released without flash encryption. Now we have decided to enable encryption due to obvious reasons and the whole procedure is working fine (Using ESP32 generated keys). However, a clear limitation I have detected is that a device running a non-encrypted v...

It worked! thanks

I forgot to mention it but I also tried to set FLASH_CRYPT_CNT to 0 but this is the output, so I cancelled the operation: espefuse.py -p COM6 burn_efuse FLASH_CRYPT_CNT 0 espefuse.py v2.8 Connecting.... WARNING: New value contains some bits that cannot be cleared (value will be 0x1) Burning efuse FL...

Either disable encryption (on the chip, not in the project) using espefuse.py or flash using the encrypt option Thanks WiFive, yes, that is exactly what I was looking for (disable encryption on the chip) but unfortunately "burn_efuse" with value 0 for DISABLE_DL_ENCRYPT and DISABLE_DL_DECRYPT retur...

Hi, I was making some initial tests with flash encryption in DEVELOPMENT MODE (no secure boot). When I finished, I just disabled flash encryption in menuconfig and then tried to flash again a new firmware version. Unfortunately this is the oputput I get from by board: rst:0x10 (RTCWDT_RTC_RESET),boo...