Thanks for your valuable response.

Hi, Thanks for your response. For TCA6424 I had already added pull up resistor to the RESET pin. I can control the LED normally as code flows on, but the main concern with unit time flicker on LED unit at the time when the board is powered ON. Footnote: The direction of port PA00 configured as outpu...

I tried to interface TCA6424ARGJR I/O Expander with ESP32 via, I2C protocol I am setting the Configuration Registers first as output for port pin P00 in I/O expander and then writing into output port register as value 0(set to low level) that have connected LED to the P00 pin. I am facing an issue w...

Thank You very much ESP_Angus for your valuable suggestion.

When I am using AWS_IOT(esp-idf-v3.1.3\examples\protocols\aws_iot\subscribe_publish) example code of ESP-IDF version-3.1.3 I am facing an issue. I am setting two WiFi hotspts and trying to switch between them if data connection is not present in any one of the WiFi hotspot. If data connection is not...

I am working with two boards having ESP32-WROOM-32U and I am using the example code of ESP-IDF-v3.1.3(examples/protocols/aws_iot). I have an AWS account which I am using for communication between board and server. I am facing a problem in data communication between the AWS server and my boards. Tryi...

Hello, When I am testing with the AP mode of the ESP32 with ESP IDF v3.1.3 . The Wi-Fi module which is set as an AP mode was successfully connected with Mobile or Tablet with the configured SSID and Password. The request sent from the browser to the ESP32 and response page sent to the browser from t...